________________________________ From: Sandeep Vadiraj Sent: Monday, January 22, 2018 11:41 AM To: linus(a)sunset.se Cc: Aaron Smith Subject: radsecproxy v1.6.9 on mips Hello, We are trying to build the radsecproxy for a mips platform. We are successfully able to make a cross platform build of 1.6.6 and install on the device. But when I try to make a connection to the server at the other end running 1.6.9 proxy it fails. Are these two versions compatible? [Encl. radsecproxy_ap.conf and radsecproxy_server.conf] We are just trying to get the udp traffic to pass through from the ap to the server. Another question is when we make a crossplatform build of 1.6.9 the build is successful but when we try to start the service on the mips device. It actually fails with the following error message # /usr/sbin/radsecproxy pthread_attr_setstacksize failed. Looking at the discussions in the mailing list tried adding the code below to radsecproxy.h: #define PTHREAD_STACK_SIZE 32768 +#if defined(PTHREAD_STACK_MIN) +#if PTHREAD_STACK_MIN > PTHREAD_STACK_SIZE +#undef PTHREAD_STACK_SIZE +#define PTHREAD_STACK_SIZE PTHREAD_STACK_MIN +#endif +#endif Still I could not get it working as it fails with the same error message. Is there any work around for this issue? Look forward to your earliest response. Regards, Sandeep K V